UPS

ONLINE-UPS

In this type of UPS, the system always remains on battery, whether mains ac is present or not. When mains ac is present, it provides power to DC supply of inverter section as well as charges the battery simultaneously. When mains ac is not present, it will run the connected load till the battery has a recommended dischargeable level.

Features:

TECHNICAL SPECIFICATIONS
RATED OUTPUT CAPACITY 0.5KVA TO100 KVA single & three Phase USING I.G.B.T
INPUT VOLTAGE 170 – 270VAC TWO WIRE
330 – 470VAC FOUR WIRE
INPUT FREQUENCY 47 – 53Hzs
RECTIFIER CHARGER AUTOMATIC float cum boost charge
BATTERY INPUT 48/60/120/180/192/240/360VDC
OUTPUT VOLTAGE 230V+or- 1%
OUTPUT FREQUENCY 50Hz+or- .25%
INVERTER EFFICENCY 90%
WAVE FORM SINE WAVE
LOAD POWER FACTOR .8Lag
OVERLOAD CAPACITY 120% for 1min, 150% for 10sec
CONTROL METHOD SPWM
SWITCHING FREQUENCY 12.5 KHz
CIRCUIT METHOD DOUBLE CONVERSION
AMBIENT TEMPERATURE 0-50 Degrees Celsius
AUDIBLE NOISER 45-55 dB at 1.5 Meters
COOLING FORCED AIR TYPE




OFFLINE-UPS

In this system, the load is normally on Mains power supply. This may be regulated to some extent by an in-built voltage regulator. When the Mains power fails, the inverter takes over and supplies power to the load while draining the battery.

Features:

  • Surge and Spike protection
  • Overload, Low battery, Over Charge
    and Short Circuit Protection
  • Micro Controller based design for
    optimum performance and reliability
TECHNICAL SPECIFICATIONS
VA Rating 600, 750, 1200, 1600&2200, 3000&3500 VA
Input voltage 145-285
Input DC voltage 12, 24, 36&48V
Output voltage 220 + 10 %
Output frequency 50 Hz + 1 %
Output wave form Quasi Square
Charging current 5 A to 10 A
Charging mode CC, CV
Power factor 0.8 Lag to unity
Inverter efficiency 90% approx.